Oblique end cutter with long 45° head, full flush cut, 117.5 mm - Lindström 8247 CO

Between tall components and close to the board, a straight side cutter often cannot reach. The 8247 CO gets there with its long 45° head and cuts leads up to 1.0 mm flush.

Benefits in use

• Long head angled at 45° for deep cutting points.
• Full flush cut without a sharp wire stub.
• Cutting capacity copper wire 0.2 to 1.0 mm.
• High-alloy ball bearing steel for long edge life.
• Compact 117.5 mm overall length, weighs 54 g.

Applications

Trimming component leads after soldering, rework and repair on populated assemblies, precision mechanics and cable assembly with thin wires.