Separator for SMD Spool Rack, Conductive, 180 x 180 x 2 mm - Warmbier 5200.180.180.2

Without a divider, SMD reels lean against each other in the compartment and can only be taken out as a stack. This separator of 180 x 180 x 2 mm keeps every reel on its own and is conductive itself, so no insulating surface appears inside the storage compartment.

Benefits

• Polystyrene made permanently volume conductive by carbon, so the property sits in the material and is not washed off during cleaning.
• Typical point to point resistance of 10^4 - 10^5 ohm keeps the separator in the conductive range and prevents a charge trap between the reels.
• A thin sheet of only 2 mm costs almost no space in the compartment and still divides cleanly.
• Format of 180 x 180 mm suits the division of smaller reel compartments.
• Available singly, so the layout of an existing rack can be refined step by step.

Application

The separator is used in the SMD component store and at setup stations inside the EPA to divide reel compartments. Conductive aids belong on grounded surfaces there, so that the charge they collect flows to the common ground point.