Precision circlip pliers for internal circlips in bore holes with overexpansion guard, 130 mm - Knipex 48 41 J11

An internal circlip only seats reliably if it is not distorted while being fitted. The 48 41 J11 precision circlip pliers support the ring on large contact faces at the tips and limit the spread with an adjustable end stop. 130 mm overall length, 105 g, made to DIN 5256 D.

Benefits

• Inserted tips instead of turned tips, up to 10 times longer service life in continuous operation.
• Overexpansion guard with an adjustable end stop, the ring is only spread as far as needed.
• Adjustment by hexagon socket screw, quickly matched to the ring size in hand.
• Large contact faces on the tips, so circlips are not distorted and go in easily.
• Bolted joint for precise, zero backlash operation of the pliers over their whole service life.
• Non-slip plastic coating on the handles, 130 mm overall length at 105 g.

Areas of use

Series assembly, workshop repair and test benches. The adjustable end stop pays off in particular when the same ring size to DIN 5256 D is fitted over and over.

Standards and conformity

The pliers comply with DIN 5256 D for circlip pliers for internal circlips. According to the manufacturer they contain no substances of very high concern under REACH. The RoHS directive does not apply to this product.