Spare punch for punch lock riveter 90 42 340, 70 x 10 mm - Knipex 90 49 340

The punch takes the full forming load on every joint, so wear runs high in repetitive dry walling work. This spare punch measuring 70 x 10 mm restores the performance of the punch lock riveter 90 42 340 instead of replacing the whole tool.

Benefits

• Genuine Knipex spare part, explicitly designated for the punch lock riveter 90 42 340.
• Keeps in service the tool that joins metal sections without screws and without rivets.
• Matched to the working range of the tool, that is U- and C-shaped sections with a maximum of 1.2 mm sheet thickness, two layers of 0.6 mm each.
• A fresh punch restores clean forming through the sheet package, so the low hand force from the optimum lever transmission is preserved.
• Small part at 70 x 10 mm and 76 g, easy to carry permanently as a reserve.

Areas of use

Upkeep of the own dry walling tools in interior fit-out and shop fitting. Worth keeping in reserve wherever many section joints are made every day and a tool out of action holds up the partition wall. Together with the spare die 90 49 340 M the complete forming set can be renewed.

Standards and conformity

According to the manufacturer the part contains no substances of very high concern under REACH. The RoHS directive does not apply. The manufacturer does not state a tool standard for this spare part.