Flat combination wrench 6 mm, 12-point Dynamic-Drive profile, chrome-plated - Bahco 111M-6

Fasteners with a width across flats of 6 mm can be approached from two sides with this wrench. The open end sits at 15 degrees to the shaft and, together with the thin head, allows repositioning in a 30 degree pattern, while the ring end offset by 15 degrees keeps fingers clear of the assembly. Both ends use the 12-point Dynamic-Drive profile, which places the load on the flanks of the fastener and spares the corners. Overall dimension as declared by the manufacturer 112 mm.

What defines this wrench

• 12-point Dynamic-Drive profile grips the flanks of the fastener, which extends the life of bolts and nuts and still holds heads that are already worn.
• Jaw at 15 degrees and a thin head reach fasteners with little space around them, and repositioning works in a 30 degree pattern.
• Ring end offset by 15 degrees creates clearance between hand and workpiece on flat surfaces.
• U-shaped shaft spreads the load in the palm and presses less than a round section when the bolt is pulled tight.
• Large size marking 6 mm on both sides saves searching in a set or in a roll holder.
• Chrome-plated micro-matt surface on a high-performance steel alloy stays controllable with oily hands and wipes clean.

Applications

Precision mechanics, electronics manufacturing, control cabinet assembly, fixture building and service work on small fasteners where a slim head decides whether the bolt can be reached.

Standards and conformity

The wrench follows ISO 691, ISO 7738, ISO 3318, ISO 1711-1 and DIN 3113. The manufacturer property table declares it as not ESD-safe, so the grip area is not dissipative to IEC 61340-5-1. The wrench also carries no VDE insulation to IEC 60900 and is not intended for live working.