Manual solder paste dispenser DPM with metal mechanism for 3 cc and 5 cc - JBC DPM-C

Too much paste means bridges, too little means cold joints. The manual DPM dispenser shortens the travel between finger and application point, which makes the amount per stroke far more predictable. It takes syringe barrels of 3 cc or 5 cc and works with solder paste, adhesive and flux.

What the dispenser delivers

• The finger contact point sits very close to the application point, giving better control over the amount released.
• Smooth paste feed even on small and hard to reach components.
• A metal mechanism instead of plastic, built for reliable performance under intensive use.
• Accepts syringe barrels of 3 cc and 5 cc, so the container size matches the batch size.
• Compatible with a wide choice of dispensing needles and tips, the resolution is set by the needle.
• Flat body of 130 x 66 x 16 mm keeps the tool within reach next to the assembly.

Applications

• Rework on SMD assemblies and paste application before hot air soldering
• Soldering multi-pole SMD components with hot air
• Applying adhesive and flux in the lab, in prototyping and in repair

Compatibility and scope of delivery

The dispenser is supplied on its own. Solder paste and dispensing needle are not included. Matching syringe barrels of 3 cc and 5 cc as well as stainless steel and plastic needles are available separately. The manufacturer offers the plunger for the DPM as a spare part.

Standards and compliance

The manufacturer property table does not rate the dispenser as ESD safe. Use inside an EPA should be cleared with your own ESD coordinator. The manufacturer is JBC Soldering SL in Spain.