Desoldering tip D530 pointed, 1.1 mm inner and 2 mm outer diameter, straight - JBC D530017

When desoldering through hole parts, the gap between pin and tip opening decides whether the solder is drawn off or stays in the plated hole. The D530017 uses a 1.1 mm inner diameter at a 2 mm outer diameter and keeps that gap deliberately small.

Benefits in use

• Inner diameter of 1.1 mm matched to leads just below that size so the suction does not pull air past the joint.
• Outer diameter of 2 mm keeps the tip slim enough for closely spaced pads.
• Pointed, straight geometry for placing the tip square on the board.
• Part of the D530 tip series, so it can be swapped against other diameters from the same range.
• Listed by the manufacturer as fitting the DT530 desoldering iron.

Applications

Desoldering of through hole parts on single and multilayer boards, repair, rework and component recovery. Suitable for lead diameters that fit into the 1.1 mm opening.

Notes on use

The manufacturer recommends a small distance between the pin and the tip opening so that air intake works at its best and the cylinder stays easy to clean. The property table does not rate the tip itself as ESD safe.