Xcelite Pro Series ESD diagonal cutter, flush cut, tapered relieved head - Weller S1415JSNN

After soldering, no sharp lead ends may stand above the joint. This diagonal cutter trims component leads flush across a 19.4 mm cutting edge, and the tapered relieved head of 15.1 mm width reaches in between densely placed parts. The Pro Series version is listed as ESD safe by the manufacturer.

Benefits in use

• Flush cut leaves no sharp lead ends standing above the solder joint.
• Cutting edge of 19.4 mm trims several leads in a single pass.
• Tapered relieved head of 15.1 mm width works between closely placed components.
• Head thickness of 9.5 mm keeps the edges aligned on harder wire.
• ESD safe design per the property table, so the tool may stay inside an EPA area.
• Padded Pro Series handles reduce load during long cutting runs.

Applications

The cutter belongs on through hole assembly benches, in rework and in board repair. It trims component leads and hook-up wire after soldering.