Xcelite Pro Series ESD diagonal cutter 101.6 mm, flush cut, relieved head - Weller S424JSNN

Leads on densely populated boards call for a short cutter that stays between the parts. This diagonal cutter measures 101.6 mm, trims flush across a 15.9 mm cutting edge and carries a relieved head of only 7.9 mm thickness. The Pro Series version is listed as ESD safe by the manufacturer.

Benefits in use

• Flush cut trims component leads without leaving a standing wire end.
• Head thickness of only 7.9 mm reaches between low seated components.
• Cutting edge of 15.9 mm at 14.7 mm head width suits fine lead wire.
• Overall length of 101.6 mm gives short lever travel and close control of the cut.
• ESD safe design per the property table, so the tool may stay inside an EPA area.
• Padded Pro Series handles for longer cutting runs.

Applications

The cutter belongs on through hole assembly benches, in rework and in board repair. It trims component leads close to the board surface.