Kraftform 7452 ESD torque screwdriver customised pre-set 0.9-1.5 Nm, 1/4" Rapidaptor - Wera 05074824010

For ESD workstations where the same torque is always required, Wera supplies the Kraftform 7452 ESD with a customised value set at the factory within 0.9-1.5 Nm. No setting is needed at the workplace and the surface resistance of ≤ 10⁹ Ohm protects the components.

Benefits

• ESD-safe tool thanks to surface resistance of ≤ 10⁹ Ohm
• Customised factory pre-set within the 0.9-1.5 Nm measuring range, for constant torque and repeat accuracy
• Only adjustable with an extra tool (re-calibration kit 05137003001), then check with an off-the-shelf torque tester
• Rapidaptor quick-release chuck for rapid change of 1/4" bits
• Unlimited loosening torque and multi-component Kraftform handle with hard and soft zones

Applications

Series assembly and quality assurance in electronics production and ESD protected areas (EPA) with a specified tightening torque. Please note: 1 Ncm = 0.01 Nm.

Standards and safety

The resistance requirements for ESD screwdriving tools are specified in DIN EN 61340-5-1, which includes a handle made of a defined conductive material. The chuck is designed for bits to DIN ISO 1173-C 6.3 and E 6.3.