Electronic Super Knips ESD with wire clip, cutters 54 HRC, 125 mm - Knipex 78 13 125 ESD

On an ESD protected assembly bench the finest wires have to be cut cleanly, without the offcut flying off and without static discharging through the tool. The Electronic Super Knips 78 13 125 ESD has electrically dissipative handles, a wire clip and precisely shaped tips that cut flush wires from 0.2 mm dia.

Benefits

• Precision cutter for the finest cutting work, for example in electronics and precision mechanics.
• Electrically dissipative handles, the tool meets DIN EN 61 340-5 for ESD protected areas.
• Ground, very sharp cutting edges without bevel. The shear cut with a controlled micro offset of the cutting edges gives a long service life and an ultra precise cut even on the thinnest wires.
• Wire clip included, so the cut off pieces do not fly away uncontrolled.
• Extremely smooth action for fatigue-free work, with opening spring and opening limiter. The joint uses a stainless steel rivet.
• INOX tool steel, cutting edge hardness approx. 54 HRC. Medium hard wire is cut up to 1.0 mm dia.

Areas of use

Assembly, rework and repair of electronic modules at ESD workstations, plus precision mechanics, laboratory work and prototyping. At 57 g and 125 mm the cutter stays light in the hand even over long production runs.

Standards and conformity

The cutter complies with DIN ISO 9654 and DIN EN 61 340-5. According to the manufacturer it contains no substances of very high concern under REACH. The RoHS directive does not apply to this product.