Electronic Super Knips® electronics side cutter 125 mm, burnished, wire catcher, blister card - Knipex 78 71 125 SB

When cutting component legs on a circuit board, the wire end must not fly off uncontrolled, and the cutting edge should still work cleanly after thousands of cuts. The burnished Electronic Super Knips® 78 71 125 therefore combine a wire catcher with induction hardened cutting edges of around 62 HRC and cut flush wires from 0.2 mm diameter. This version is supplied on a self-service blister card.

Advantages

• Wire catcher holds the offcut, so cut wire ends cannot fly away uncontrolled.
• Precision pliers for the finest cutting work, for example in electronics and precision engineering.
• Ground, very sharp cutting edges without bevel, precisely shaped tips also cut flush wires from 0.2 mm diameter.
• Shear cut with controlled micro cutting edge offset for a long service life and an ultra precise cut even of the thinnest wires.
• Cutting edges additionally induction hardened, hardness approx. 62 HRC, burnished special tool steel.
• Joint with stainless steel rivet, extremely easy action, opening spring with opening limiter.

Areas of use

Electronics production and repair, assembly and rework of printed circuit boards, precision engineering, laboratory and model making. The wire catcher pays off wherever cut wire ends must not drop into the assembly.