Trolley jack 3 t with 800 mm lifting height and 130 mm minimum height - Bahco BH13000L

A van or caravan sits high, and an ordinary workshop jack runs out of travel at around 500 mm. This jack takes 3000 kg to a lifting height of 800 mm and still slides under low sills thanks to a minimum height of 130 mm. The 1280 mm frame places the saddle far under the vehicle.

Benefits in use

• Lifting height of 800 mm at a minimum height of 130 mm, which puts all-wheel drive vehicles, vans and caravans within reach.
• Load capacity of 3000 kg for vehicles that are too heavy and too high for a classic car jack.
• Double piston hydraulics, lifting is up to 50 percent faster than with a single piston system.
• Frame length of 1280 mm for a deep reach under the vehicle.
• Polyurethane coated steel wheels for quiet manoeuvring, piston and spring are protected against dust and dirt.
• Rubber pad on the saddle and a foam sleeve on the lifting rod protect paintwork and body panels.
• Safety pressure valve and controlled lowering speed for a measured descent.

Technical data

Applications

Workshop and service work on all-wheel drive vehicles, vans, minibuses, caravans and agricultural vehicles. Also for yards and fleets where one device has to cover different vehicle heights. The dead weight of 102 kg argues for a fixed place in the workshop.

Scope of delivery and safety note

The jack is delivered as a single unit. A jack is a lifting device, not a support device. Before any work under the load, approved axle stands belong under the vehicle, and the ground must be level and load bearing.

Standards and conformity

CE certified in accordance with the Machinery Directive 2006/42/EC and BS EN 1494. The article is not ESD safe, the property table lists ESD as no.