Tool case for photovoltaics, empty, impact-resistant plastic with foam insert, 345 x 80 x 280 mm - Knipex 97 91 01 LE

On the roof and in the inverter room it matters that every tool has its fixed place. This empty tool case with external dimensions of 345 x 80 x 280 mm holds the tools of the photovoltaic range in pre-formed recesses, so a missing item is obvious at a glance.

Benefits

• Impact-resistant plastic case, built for daily transport to the site.
• Foam insert with recesses for the tools, anything missing is spotted immediately.
• Places for 2 crimping dies and 2 locators, the accessories stay with the tool.
• Flat height of 80 mm at 345 mm width and 280 mm depth, suited to van shelving and workshop cabinets.
• Empty weight 650 g, the case stays portable once equipped.

Areas of use

Installation and service work on photovoltaic systems, building up an individual tool set along the lines of the equipped case 97 91 03, and replacement for a damaged case. It also suits carrying an existing set of insulation stripper, cable shears and crimp system pliers in good order.

Standards and conformity

The manufacturer does not state a tool standard for this product. According to the manufacturer the case contains no substances of very high concern under REACH. The RoHS directive does not apply.