Tente ESD swivel caster 100 mm with brake, top plate 77 x 67 mm - A1-ESD EP0806066

Anyone fitting out a trolley, a shelf unit or a workbench for the ESD protected area needs casters that do not electrically isolate the structure and that stay put during loading and unloading. This swivel caster has a 100 mm wheel, a wheel centre of electrically conductive polypropylene and a wheel brake. It is fitted with a bolt-on top plate with a mounting dimension of 77 x 67 mm.

Benefits

• Wheel centre of electrically conductive polypropylene, so the trolley stays tied into the grounding path through the caster instead of acting as an insulator.
• Tread of TENTEprene, a thermoplastic rubber in grey, non-marking and therefore free of abrasion streaks on light-coloured shop floors.
• The wheel brake blocks the wheel, so the structure holds its position during loading and testing.
• Swivel head with a double ball race keeps steering easy even when the trolley is pushed from the side.
• Sheet steel housing, bright zinc-plated and blue passivated, intended for dry indoor use.
• The 77 x 67 mm top plate bolts flat onto the frame and transfers the load across the whole plate.
• The 100 mm wheel runs noticeably more smoothly over floor joints, cable bridges and door sills than smaller diameters.

Technical data

Application

Typical use is on transport and shelf trolleys, material carts, workbenches and chassis inside an EPA, wherever populated assemblies are moved and the whole structure has to stay electrostatically controlled. The brake is needed at handover and test positions where the trolley must not roll away during work. The range is also supplied in further wheel diameters, so swivel and fixed casters on one chassis can be matched to the same overall height.