Shielded measuring probe 63 mm 2.3 kg with BNC and 4 mm sockets - Iteco 9265065

In the gigaohm range the contact force of the electrode decides whether readings can be repeated. Shielded probe 9265.065 puts 2.3 kg of dead weight onto a measuring electrode of 63 mm diameter, so the operator does not have to press down.

Features

• 2.3 kg dead weight gives a constant contact force and keeps readings comparable from one measurement to the next.
• 63 mm measuring electrode of conductive rubber that adapts to uneven surfaces.
• Fully shielded body, which keeps interference low at high resistance values.
• One BNC connector plus two 4 mm sockets, so the probe works with a coaxial cable or with test leads.
• Measuring electrode on the BNC inner conductor and a red 4 mm socket, shield on the BNC outer conductor and a grey 4 mm socket.

Applications

• Point-to-point measurement on worktops, mats and floors using two probes.
• Measuring the resistance to ground of a surface against the ground point.
• Volume resistance measurement together with counter-electrode 9265.047.
• Routine EPA checks as part of an ESD control programme.

Compatibility and scope of supply

Supplied as one probe. It works with the megohmmeters GigaLab EVO 9265.063 and GigaLab EVO PLUS 9265.066 as well as with Labeohm EVO 9265.051 and Labeohm EASY 9265.055. Kits 9265.056 and 9265.057 each contain two of these probes. For floor readings taken standing up, T-handle 9265.072 can be screwed on.

Standards and origin

For resistance measurements to IEC 61340-5-1. Made in Italy by Iteco.