ESD extraction arm DN100, 3 joints, 1710 mm, ATEX, black, table mounting - Alsident 100-9065-1-6

Soldering and repairing large assemblies in an ESD area requires an arm that reaches far across the bench and reliably dissipates charges. The Alsident 100-9065-1-6 is a System 100 AS extraction arm with 1710 mm reach, 3 joints and a Ø 100 mm tube for table mounting, designed for airflows of 140 to 400 m³/h.

Benefits

• 1710 mm reach with 3 joints, an external gas spring carries the long arm and holds it in the chosen position
• Designed for 140 to 400 m³/h, suited to larger volumes of vapour or dust
• Tubes and joints in black conductive polypropylene, approved for ESD and Ex areas to EN 80079-36:2016 and EN 80079-37:2016, marked Ex II 1 GD
• Threaded rods, springs and finger screws in acid-resistant AISI 316L stainless steel, maintenance-free O-rings
• Dismantled and reassembled without tools, maintenance is limited to cleaning as needed

Specifications

Applications

• ESD areas in electronics, soldering and repair stations for large assemblies
• Laboratories and industrial areas with special requirements for charge dissipation
• ATEX areas, where the manufacturer recommends spark-free brackets in acid-resistant stainless steel (EN 1127-1 clause 5.3)

Compatibility and scope of delivery

• System 100 AS hoods: 1-10024-6 (Ø 200), 1-10035-6 (Ø 385), 1-10050-6 (Ø 500) and 1-1004228-6 (420 x 280), ordered separately
• Table mounting via the U-profile 30-100-5, ordered separately
• Reducing sleeve 4-100125-6 (Ø 100 to 125 mm) and protective grid 5-18-6 available as accessories
• Supplied with a fixed earth lead for Ex areas and a separate earth lead with 1 MΩ resistor for ESD areas