ESD extraction arm DN75, 2 joints, 650 mm, ATEX, table mount - Alsident 75-45-1-6

Made of conductive black polypropylene, this table arm with 650 mm reach is approved for ESD areas and potentially explosive atmospheres (ATEX). Alsident System 75 uses Ø 75 mm tubes and is designed for airflows of 80 to 180 m³/h. In electronics production or at stations with solvent vapours it dissipates static charge through the earthing cable.

Benefits

• Self-supporting design: threaded rods and springs sit inside the arm, so the hood stays in any position and is easy to guide to the source
• Tubes and joints of conductive polypropylene, supplied with an earthing cable, with an additional 1 MΩ resistor for ESD areas
• Approved for ESD and Ex areas to EN 80079-36 and EN 80079-37, marked Ex II 1 GD
• Threaded rods, springs and thumb screws of acid-resistant stainless steel AISI 316L, maintenance-free O-rings
• Dismantles by hand in a few steps without tools, maintenance is limited to cleaning as needed

Specifications

Applications

• ESD protected areas in electronics
• Potentially explosive atmospheres (ATEX)
• Laboratories with solvent vapours

Compatibility and scope of delivery

• Part of Alsident System 75, tube Ø 75 mm
• Scope of delivery: extraction arm only, hood and bracket are ordered separately
• Brackets: table bracket 2-7510 or U-profile 30-75-5
• Conductive hoods: 1-7525-6, 1-7524-6 (Ø 200 mm), 1-7535-6 (Ø 385 mm), protective grille 5-17-6, reducers 4-8075-6 and 4-10075-6
• In ATEX areas the manufacturer recommends brackets of acid-resistant stainless steel, e.g. wall bracket 2-195-10-22-6