ESD safety low shoe ERGO-MED 2000 S1, mesh upper, width 12, black and grey - Atlas 86412

The ERGO-MED series is the part of the Atlas range built for orthopaedic requirements. The ERGO-MED 2000 is a class S1 ESD low shoe that an orthopaedic shoemaker may modify under DGUV rule 112-191, that is with a raised sole or heel. Measured as the person, shoe and floor system to DIN EN 61340-5-1, the through resistance stays below 100 MOhm, so the wearer charge drains away before it reaches an assembly.

EN ISO 20345 allows antistatic footwear anywhere between 100 kOhm and 1000 MOhm. For the ESD version Atlas additionally guarantees the narrower value below 100 MOhm, which is what an EPA set up to DIN EN 61340-5-1 asks for.

What sets this model apart

• Certified for orthopaedic modifications to DGUV rule 112-191. That is the practical difference to an ordinary S1 shoe. Where a foot deformity calls for a raised sole, the shoe stays compliant after the change instead of losing its approval.
• Safety class S1 to EN ISO 20345 means a 200 joule toe cap, closed heel area, energy absorption in the heel and antistatic construction. For dry indoor areas without a nail risk this is the lightest sensible level.
• The MPU INNOFLEX System is laid out as a complete outsole concept and supports every phase of roll off. The MPU REBOUND SYSTEM handles cushioning and returns part of the impact energy.
• A mesh upper and the clima-stream concept keep breathability high and balance the moisture inside the shoe. Over eight hours in a warm hall that is the difference between a dry foot and a wet one.
• Also approved for orthopaedic insoles to DGUV rule 112-191, the marking inside the shoe is decisive.
• This article is the extra wide width 12. It is meant for feet that still find the already generous standard width 10 tight across the ball, and it saves buying a size too long as a workaround.

Technical data

Areas of use

Electronics manufacturing and board assembly, test and measuring benches, laboratory, order picking inside the EPA, workplaces with an occupational health or orthopaedic requirement. As an S1 model without penetration resistance and without a water repellent upper the shoe belongs in dry indoor areas.

Standards and conformity

EN ISO 20345, safety class S1, slip resistance SRC. ESD property to the person, shoe and floor measuring method of DIN EN 61340-5-1 with a through resistance below 100 MOhm. Personal protective equipment of category 2 under PPE regulation (EU) 2016/425. Approved to DGUV rule 112-191 for orthopaedic insoles and for certified orthopaedic modifications.

Sizes

Atlas lists the ERGO-MED 2000 in EU sizes 36 to 50. This article covers the full range in width 12 (extra wide), pick the size in the variant selection.