EPA Floor Marking Tape with Arrows, Yellow with ESD Logo, Self-Adhesive, 50 mm x 66 m - Desco 210310

Where the protected area starts and how to enter it should be obvious at a glance. This 50 mm tape does both: the ESD logo marks the EPA boundary as IEC 61340-5-1 requires, and the printed arrows direct people to the intended entrance. With 66 m per roll, larger production floors can be outlined in one run.

Key benefits

• Direction arrows, ESD logo per EN 61340-5-1 and "ESD Protected Area" print on one tape
• 66 m roll length at 50 mm width, fewer joins and roll changes on long boundaries
• PVC carrier with clear polypropylene laminate, the print survives wet cleaning
• Adheres very well to synthetic floor tiles and also holds on concrete
• Lasts three to eight months, longer in low-traffic areas

Applications

Boundary marking and wayfinding at ESD protected areas in electronics production, labs and repair. The tape is not antistatic, as it sits on the boundary, outside the EPA.

Standards

The logo complies with EN 61340-5-1. The marking meets the IEC 61340-5-1 requirement for clearly identified EPA boundaries, and IEC TR 61340-5-2 lists floor tape as a suitable method.