Lead-Free Desoldering Braid, 1.905 mm x 3.05 m, Antistatic Bobbin, Pack of 25 - Desco LF-C-10AS

Lead-free solder needs more heat to remove than tin-lead. This Desco braid carries a flux formulated for the higher activation temperatures of lead-free processes and wicks solder quickly from pads and leads. At 1.905 mm wide and 3.05 m (10 ft) long, this version suits larger lands and through-hole joints.

Key benefits

• Made for lead-free solder: flux activates at higher temperatures, type L0 per IPC J-STD-004B
• Economical: concentrated fine copper weave of 96 strands of 42 AWG (6 x 16) uses less braid per joint
• Quick on and off: clean, oxide-free copper wire in a tight weave
• High surface insulation resistance (High SIR) per Bellcore GR-78-CORE and IPC Test Method III, compatible with R, RA, RMA and NC fluxes
• ESD safe: static dissipative bobbins in line with the ESD Association standard, colour code green identifies the width

Applications

Desoldering and pad clean-up during rework and repair of printed circuit boards, computers, mobile phones and other electronic assemblies, in lines that use RMA no-clean fluxes. The dissipative bobbins can stay at the workstation inside the EPA.

Standards

Flux to ANSI/J-STD-004 and IPC J-STD-004B type L0, surface insulation resistance per Bellcore GR-78-CORE (TR-TSY-000078) and IPC Test Method III. Every bobbin is stamped with a lot code and a certificate of compliance is available from the manufacturer. Desco warrants the braid for two years from manufacture when stored in its original container.