Lötspitze verlängert, flach 8,0 x 1,7 mm, Frontfläche verzinnt für Lötroboter-Tools 9018M, 9018BMT - Quick QU911G-80D-08

On flat tips the front face decides how heat is transferred, and on this version that face is tinned from the factory. The end measures 8.0 x 1.7 mm and is available as a wetted surface right away, so the process does not have to establish wetting first.

Why it works

• Pre-tinned front face, the contact area takes solder from the first cycle instead of after a run in phase.
• End dimensions 8.0 x 1.7 mm, area contact for wide pads and terminal surfaces rather than line contact.
• Extended body, contacts that sit deeper or offset are reached without reworking the holder.
• Material thickness 1.7 mm, adequate heat reserve despite the longer path back to the cartridge.
• Straight design, vertical approach and unchanged zero point logic in the program.
• QU911G cartridge format, RoHS compliant and usable with lead free alloys.

Application and compatibility

Intended for wide soldering areas, flat terminals and recessed contacts where the end face of the tip is the actual working surface. Fits the 9018M and 9018BMT soldering robot tools and therefore the ET9181, 9594FYA, ET9494E, 9584EYA and ET9494F-A robots plus further models of the range. Supplied as a single tip.