Soldering tip chisel 30° 2.5 mm SSC 600 series - Metcal SSC-636A

Temperature sensitive components do not tolerate an overheated tip. The SSC-636A cartridge of the SSC 600 series uses Metcal SmartHeat induction technology and holds the tip temperature constant at 357 °C, controlled by the Curie point of the heater layer instead of a sensor.

Benefits

• Fixed tip temperature of 357 °C with no calibration and no temperature setting
• 600 series for temperature sensitive applications and low thermal masses
• Chisel geometry with 2.5 mm width and 9.9 mm tip length
• Fits the MFR-H6-SSC handpiece of the MFR-1160 and MFR-1161 soldering systems
• Can also be used on the SP200 soldering system

Technical data

Applications

Through-hole components, connector rows, pads with a larger copper area, stranded wires and ground points, plus general repair and rework on assemblies.

Compatibility and scope of delivery

The cartridge plugs directly into the MFR-H6-SSC handpiece and therefore suits the Metcal MFR-1160 and MFR-1161 soldering systems as well as the SP200 system. It can be changed during operation without tools and reaches working temperature within seconds. Scope of delivery is one SSC-636A soldering cartridge, order unit piece.