Soldering tip conical 0.4 mm T series for TMT-5000S - Thermaltronics TM60CS150

Reworking single pads on a densely populated board depends on a slim tip geometry. This conical T series tip measures 0.4 mm across the point at 13 mm tip length and reaches joints that sit between neighbouring components.

Benefits

• 0.4 mm tip width for fine pitch pads, wire ends and test points
• 13 mm tip length balances access with stiffness
• Curie point heating holds 325-358 °C with no calibration and no temperature control
• Cartridge design keeps heater and sensor in the tip, both are replaced with it
• RoHS compliant and intended for lead-free alloys

Applications

Used for hand soldering and rework of SMD parts, tacking thin stranded wire and placing single joints on connectors. The narrow point also suits track repairs and work under a stereo microscope.

Compatibility and scope of delivery

Fits the SHP-T hand piece and therefore the TMT-5000S-1 and TMT-5000S-2 soldering stations. Supplied as a single cartridge, order unit piece, packed at 117 mm x 33 mm x 13 mm.