Tweezer soldering tip pair chisel 30° 1.78 mm T series - Thermaltronics T80TZ018B

Chip resistors, diodes and small capacitors can only be removed without lifting pads if both terminations reflow together. This tip pair from the T tweezer series does that with a 1.78 mm chisel face at a 30° working angle and a tip length of 10 mm.

Benefits

• Supplied as a matched pair so both tweezer arms behave identically in geometry and heat delivery
• Self regulating Curie point heating stays in the 420-475 °C band with no calibration and no temperature dial
• The 1.78 mm chisel face moves far more heat than a conical tip of the same size
• 30° angle keeps the joint in view while the hand stays low over the board
• RoHS compliant and rated for lead-free alloys

Applications

Removing and repositioning two-lead SMD components from 0603 upwards, rework on populated assemblies, repair of prototypes and small batches in electronics production and service labs.

Compatibility and scope of delivery

Made for the SHP-TTZ tweezer hand piece on the TMT-5000S-1 and TMT-5000S-2 soldering systems. Delivery is one pair of cartridges, a left and a right one. Hand piece and power unit are not included.