Soldering tip chisel 30° 2.5 mm T series - Thermaltronics TM70CH175

Leaded components, ground pads and terminal blocks drain heat from the joint faster than a narrow tip can replace it. The TM70CH175 answers with a 2.5 mm chisel face and a slim 10 mm body, so the joint reaches wetting temperature in one pass without the tip fouling neighbouring parts.

Benefits

• 2.5 mm chisel face carries enough heat for leaded parts and wide copper pads
• 10 mm tip length reaches joints between tall components and inside housing cut-outs
• Self-regulating T series holds 350-398 °C without any temperature setting on the unit
• RoHS compliant and made for lead-free alloys
• Cartridge design puts heater and sensor in the tip, so changes take seconds

Applications

Through-hole assembly, repair work on connectors and terminals, reflowing ground planes and larger SMD packages from 1206 upwards. Also a good choice for stranded wire terminations where a fine tip recovers too slowly.

Compatibility and scope of delivery

For the SHP-T hand piece used with the Thermaltronics TMT-5000S-1 and TMT-5000S-2 soldering stations. Supplied as one TM70CH175 tip cartridge, order unit piece.