Soldering tip conical 1.0 mm T series short geometry - Thermaltronics TM70CP303

Where a needle point cannot supply enough heat, the TM70CP303 conical cartridge with its 1.0 mm tip width is the next step up. At only 7.4 mm tip length the mass sits close to the heater, and Curie regulation keeps the temperature inside the 350-398 °C window even across a run of joints.

Benefits

• 1.0 mm point with far more thermal reserve than a 0.4 mm needle
• Very short 7.4 mm tip length keeps the heat path to the joint short
• Temperature fixed by the Curie point, no adjusting and no calibration
• Tool-free cartridge change on the SHP-T hand piece
• Suitable for lead-free solder and RoHS compliant

Applications

Soldering leaded components, plated through holes, pin headers and stranded wire connections, plus general repair work on assemblies that calls for a fine but not extremely slender point.

Compatibility and scope of delivery

Fits the SHP-T hand piece and the TMT-5000S-1 and TMT-5000S-2 stations. Delivery consists of one soldering tip cartridge.