Soldering tip sharp bent 30 degrees 0.5 mm with 14 mm reach - Thermaltronics TM70SB276

When the joint sits behind a heat sink or a connector shell, a short needle tip runs out of reach. The TM70SB276 uses the same 30 degree bent geometry but with a 14 mm tip length and a 0.5 mm working width.

Benefits

• 14 mm tip length for joints behind connectors and heat sinks
• 0.5 mm working width as a fine point geometry with more heat reserve
• 30 degree bend for a flat working angle and an unobstructed view
• 350-398 °C without recalibration, lead-free and RoHS compliant

Applications

Repair on densely populated boards, joints behind heat sinks and connector shells, rework on chip components and fine pitch terminations.

Compatibility and scope of delivery

For the SHP-T hand piece and the TMT-5000S-1 and TMT-5000S-2 stations. Scope of delivery is one TM70SB276 soldering cartridge.