Soldering tip chisel bent 30°, 1.78 mm, T series - Thermaltronics TM80CB225

A chisel blade meets pin and pad across its full width and therefore carries more heat than a cone of the same size. The TM80CB225 adds a 30° bend so that recessed or shadowed joints can be approached at a flat angle.

Benefits

• 1.78 mm blade width for wide pads, pin headers and cable lugs
• 30° bend gives a flat working angle where headroom is limited
• 10 mm tip length as a compromise between reach and thermal output
• 420-475 °C band without any calibration
• Lead-free and RoHS compliant

Applications

Soldering pin headers and cable terminations, rework on SOIC rows, connections inside flat enclosures and behind front panels.

Compatibility and scope of delivery

Fits the SHP-T hand piece and therefore the Thermaltronics TMT-5000S-1 and TMT-5000S-2 induction soldering stations. Delivery covers one cartridge, the heating element is built in and is replaced together with the tip.

The cartridge is RoHS compliant and lead-free, which makes it suitable for the usual SAC lead-free solder alloys.