ESD Grounding Cord 1.8 m with Protective Cap, 10 mm Snap / 4 mm Ring Terminal - Warmbier 2250.790

An ESD table or floor mat only drains charge while it is reliably tied to the earth point. This Warmbier grounding cord makes that connection over 1.8 m and takes the charge to ground through a 1 MOhm safety resistor.

Benefits

• The 1 MOhm safety resistor limits current flow and protects the operator around mains-powered equipment.
• 10 mm snap and 4 mm ring terminal fit ESD table and floor mats with a snap stud and screwed earth points.
• The protection cap, 43 mm in diameter, covers the contact point and keeps it clear of dust and mechanical load.
• 1.8 m of cord bridges mat to earth bar without leaving spare cable across the bench.

Application

Earthing ESD table mats at soldering, test and assembly stations, and floor mats inside the EPA. The snap presses into the mat stud, the ring terminal is screwed to the bench earthing point or to the earth bar.