Mitre shears for plastic and rubber sections, crush-free cut, 45° try square, 215 mm - Knipex 94 35 215

Cutting a sealing section to a mitre fails with pliers because the material is crushed and the joint no longer closes tightly. The 94 35 215 mitre shears cut plastic, rubber and soft timber sections without crushing and guide the cut to an exact 45° with a try square.

Benefits

• Crush-free cut on plastic, rubber and soft timber sections, the profile contour stays intact.
• Try square for 45° cuts plus markings for 60°, 75° and 90°, so mitres are repeatable without marking out.
• Exchangeable cutting base as the wearing part, the tool stays in service for years.
• Opening spring for fast cutting sequences and a locking device for safe storage.
• Blade length 56 mm for long continuous cuts in one pass.
• Chrome-plated shears with plastic sheaths on the handles, 397 g at 215 mm length.

Areas of use

Window and door construction, fitting of sealing and edge protection sections, vehicle and interior fit-out, electronics manufacturing when cutting ribbon cable to length. Wherever sections are butted at a mitre and the cut face has to stay clean.

Standards and conformity

According to the manufacturer the mitre shears contain no substances of very high concern under REACH. The RoHS directive does not apply to this product.