Crimping pliers for insulated terminals and non-insulated crimp terminals, 0.5 to 6.0 mm², 240 mm - Knipex 97 32 240

Anyone fitting both insulated terminals and non-insulated crimp terminals in a control cabinet does not want to carry two tools for the job. The 97 32 240 crimping pliers combine both profiles and cover 0.5 to 6.0 mm² in three nests, and they cut and strip the conductor in the same operation.

Benefits

• One tool for insulated terminals, insulated heat shrinkable sleeve connectors and non-insulated crimp terminals to DIN 46234.
• Three crimping nests from 0.5 to 6.0 mm², matching AWG 20 to 10.
• Cable cutter and stripping holes in the same tool, so no tool change is needed.
• Threaded holes for cutting copper and brass screws threaded M 2.6 / M 3 / M 3.5 / M 4 and M 5.
• Bolted joint for high stability and even movement.
• 240 mm lever length with multi-component grips keeps the effort low even at 6.0 mm².

Technical data

Areas of use

Control cabinet and control system building, machine and plant construction, vehicle electrics and maintenance. The tool pays off wherever insulated and non-insulated connectors occur in the same installation.

Standards and conformity

The profiles for non-insulated terminals are matched to DIN 46234. The manufacturer does not state a tool standard. According to the manufacturer the pliers contain no substances of very high concern under REACH, and the RoHS directive does not apply.