Crimping die for insulated and non-insulated wire end ferrules, 0.25 to 6.0 mm² - Knipex 97 39 08

Wire end ferrules are the standard at terminal blocks, and the ferrule barrel has to be deformed evenly across the whole cross-section range. The 97 39 08 crimping die converts the MultiCrimp crimping pliers with changer magazine to insulated and non-insulated ferrules and covers 0.25 to 6.0 mm² in three nests.

Benefits

• Three crimping nests for insulated and non-insulated wire end ferrules from 0.25 to 6.0 mm², matching AWG 24 to 10.
• Covers fine cross-sections from 0.25 mm² as used in measurement and control technology.
• Quick and easy change of the crimping dies without additional tools.
• Sorted and protected storage of the interchangeable dies in the round magazine of the pliers.
• Reliable crimping results just like fixed crimping dies.
• Consistently high crimping quality thanks to precision dies and the releasable ratchet of the pliers.

Areas of use

Control cabinet and control system building, electrical installation, measurement and control technology and mobile service work. The die pays off wherever stranded conductors are landed on terminal blocks and further crimping profiles should travel in the magazine.

Standards and conformity

The manufacturer does not state a tool standard for this die. According to the manufacturer it contains no substances of very high concern under REACH, and the RoHS directive does not apply.