Crimping pliers for non-insulated open connectors 2.8 and 4.8 mm, 0.1 to 1.5 mm², short design, 195 mm - Knipex 97 52 14

Fine conductors from 0.1 mm² upwards forgive no inaccurate crimp, especially on non-insulated open connectors. Crimping pliers 97 52 14 work with four nests for tabs 2.8 and 4.8 mm wide and cover cross-sections from 0.1 to 1.5 mm², that is AWG 26 to 16.

Benefits

• Four nests for non-insulated open connectors with 2.8 and 4.8 mm tab width, from 0.1 to 1.5 mm² conductor cross-section.
• Precision dies and an unlockable ratchet keep crimping quality constant across a whole series.
• Crimping pressure is set and calibrated at the factory, so nothing has to be readjusted.
• The head angled by 20° keeps the crimping zone in view and makes work on a harness lying flat easier.
• Short design at 195 mm and 387 g, so the pliers still cope with tight installation spaces.
• A locator for non-insulated open plug-type connectors is available as an accessory, it keeps the contact aligned while crimping.

Areas of use

Vehicle and trailer electrics, control system and cabinet building, electronics manufacturing and harness repair, wherever thin conductors are terminated on non-insulated blade terminals and receptacles.

Standards and conformity

The manufacturer states no tool standard for this product. According to the manufacturer the pliers contain substances of very high concern under REACH. The RoHS directive does not apply. The crimping die is fixed and cannot be exchanged.