ESD PCB holder, conductive polypropylene, 29 boards, 557 x 357 x 22 mm - Warmbier 5366.550.350.L

Series production delivers whole lots of populated assemblies at once. This holder, 557 x 357 x 22 mm, takes up to 29 printed circuit boards along the long side or 19 across and is moulded from permanently volume conductive, carbon loaded polypropylene.

Benefits

• Up to 29 boards lengthwise or 19 across in a single tray, which cuts the number of handling steps per lot.
• Naps of 14 mm with a 3 mm distance between them guide each board separately and prevent contact with the neighbour.
• Conductivity sits in the bulk of the plastic and survives abrasion and cleaning.
• 22 mm height on a 557 x 357 mm footprint, matching tote boxes and shelf compartments in module sizes.
• Polypropylene is washable and resistant to flux residues and isopropanol.

Application

The tray serves as lot storage at placement, test and rework benches and as an insert for in-house transport in tote boxes. Inside the EPA the conductive plastic keeps the assemblies at the potential of the grounded work surface, so no discharge travels through the components when a board is set down.