Soldering tip chisel straight 1.8 x 0.5 mm for T245 soldering iron - JBC C245171

At a manual soldering bench with changing assemblies one tip usually stays in the iron. The straight chisel 1.8 x 0.5 mm is the obvious candidate: wide enough to push heat into a ground pad, narrow enough for fine leads, with 8.1 mm of usable length.

Benefits in detail

• Chisel face of 1.8 x 0.5 mm covering the majority of joints on mixed technology boards.
• Straight orientation for a predictable approach angle and even contact on the pad.
• Cartridge of the C245 series, the widest JBC tip range with shapes from fine pitch to power soldering.
• Heater directly inside the tip, giving instant heat up and fast recovery after each joint.
• According to the manufacturer, Long Life Tips with the Sleep and Hibernation functions reach several times the usual service life.
• Fits every handle of the T245 range.

Applications

General hand soldering, SMD assembly and rework, soldering of terminal areas and base surfaces with raised heat demand, repair benches with changing assemblies.

Compatibility

For the JBC T245 handles. C245 cartridges do not fit the nano handpieces of the C105 and C115 series.