Trolley jack 10 t extra long with 150 mm steel saddle and safety valve - Bahco BH110000B

Commercial vehicles, trailers and agricultural machines can only be lifted if the jack actually reaches under the frame. This model carries 10000 kg and, with a chassis length of 1550 mm, is laid out for lifting points far from the edge. The steel saddle of 150 mm diameter spreads the load over a wide contact area.

Benefits in use

• Load capacity of 10000 kg, laid out for heavy vehicles and equipment rather than passenger cars.
• Chassis length of 1550 mm for a particularly deep reach under the vehicle.
• Steel saddle of 150 mm diameter, the load rests on a wide seat instead of a single point.
• Safety valve against accidental overload and a controlled release for safe lowering even at full load.
• Extra large rounded foot pedal and curved handle, so the jack can be run in from any position.
• Storage tray in the chassis for screws, nuts and small parts, plus steel wheels and a steel structure for a long service life.

Technical data

Applications

Commercial vehicle workshops, agricultural machinery, construction equipment and in-house maintenance. Useful wherever loads of up to 10000 kg are lifted and the lifting point sits far from the edge of the vehicle. At 117 kg dead weight the jack stays in the workshop, transport in a service vehicle is not intended.

Scope of delivery and safety note

The jack is delivered as a single unit. A jack is a lifting device, not a support device. Before any work under the load, approved axle stands belong under the vehicle, and the ground must be level and load bearing.

Standards and conformity

CE certified in accordance with the Machinery Directive 2006/42/EC. Figures for lifting height and minimum height are not part of the manufacturer data available here. The article is not ESD safe, the property table lists ESD as no.