Angled desoldering iron 160 W for D530 series tips, ESD safe - JBC DT530-A

Through hole components and leftover solder from SMD rework only come off cleanly with enough heating power. The DT530-A delivers 160 W and uses an angled shaft that keeps the view clear under a microscope or a magnifier lamp.

Benefits

• 160 W of heating power with fast heat-up and stable temperature, so ground planes and thick pads clear quickly.
• Angled design that opens the view onto the joint and relieves the hand during long desoldering runs.
• Improved air tightness in the suction channel, keeping the extraction of molten solder reliable.
• Tip locking mechanism that secures the change of D530 tips and prevents the hot tip from dropping.
• Quick change glass collector with filter set, so maintenance is short instead of stripping the handpiece.

Technical data

Applications

Rework and repair on populated boards, removal of through hole components, picking up excess solder after SMD work as well as prototyping and small series.

Compatibility

According to the manufacturer the DT530 works with the DDE and DME control units and with the MSE electric desoldering module. Tips of the D530 series.

Scope of delivery

• Desoldering nozzle D530003, already fitted
• 2x glass solder collector DT20
• 5x front seal DT30 and 5x rear seal DT35
• Spanner DT50 and 2.5 mm hex screwdriver 0033474
• 10x wool filter DT10 and 10x metal filter DT11
• Heat resistant gripper DT60
• Cleaning brush 0008297, metal brush CL6217, tip cleaning set 0965970 and spiral cleaning rods 0965760

Conformity

The manufacturer declares the handpiece as ESD safe.