Desoldering tip for pad cleaning inner Ø 1 mm outer Ø 2.7 mm for DT530 - JBC D530013

A pad covered with residual solder will not take a new component cleanly. The D530013 sits flat on the pad and guides the suction air through a slot in the contact face to the molten solder, with an inner diameter of 1 mm. The pad is cleared in a single step without smearing solder.

What the tip delivers in practice

• Slotted contact face, the suction air reaches the residual solder even with the tip lying flat.
• Inner diameter 1 mm and outer diameter 2.7 mm, matched to pads of this size range.
• The pad is cleared in one pass, follow up work with desoldering braid is usually not needed.
• Short contact times protect the pad and the solder resist.
• D530 series for the DT530 desoldering iron, changed without altering the station setup.

Applications

Preparing pads before reassembly, repair and rework on printed circuit boards, service benches in electronics manufacturing and maintenance.

Compatibility and scope of delivery

The tip belongs to the D530 series and works on the DT530 desoldering iron. One piece in geometry S1 is supplied.