Hot air station WTHA 1 with safety rest, 900 W, 50-600 °C - Weller T0053174699

Removing QFP, BGA and multi pin connectors calls for heat that covers the area and does not swing. The WTHA 1 provides 900 W for the job and holds the set value between 50 and 600 °C to within ±30 °C, while the brushless turbine trims the flow up to 110 l/min.

What it delivers in use

• 900 W at 230 V bring ground planes and multilayer boards up to process temperature in a workable time.
• The 50 to 600 °C range with ±30 °C accuracy covers lead free profiles as well as gentle preheating.
• Up to five presets for volume, temperature and time can be called up singly or run one after another as a profile, which takes manual work out of repeated rework steps.
• Tandem dual sensor control compares two measuring points and holds the set temperature even when the air flow changes.
• The multifunction LCD with adjustable backlight shows set and actual values during operation and stays readable at bright benches.
• The 90 cm heat resistant silicone hose gives freedom of movement, and at 56 dBA the station stays quiet in continuous use.
• The stackable housing with a usable lid compartment saves bench space and holds nozzles and small parts.

Technical data

Applications

Rework and repair in electronics manufacturing, removing and placing SMD parts, desoldering multi pin connectors, preheating assemblies and shrinking insulation sleeving in the laboratory and in technical service.

Scope of delivery

• Hot air station WTHA 1, 900 W, 230 V
• Safety rest for the hot air pencil

Compatibility

The station works with the hot air pencil and the nozzles of the WTHA 1 system. Without a nozzle matched to the component size part of the power stays unused.

Standards and compliance

The manufacturer declares the station ESD safe, so it suits workplaces inside an EPA. Fuse rating T4A, operation on 230 V. Manufactured by WELLER Tools GmbH in Besigheim.