WT 1012M single channel rework set with WTMT MS tweezers, 95 W - Weller T0053460699

A two terminal SMD part only leaves the board undamaged when both sides are liquid at the same time. The WT 1012M rework set provides the WTMT MS desoldering tweezers with two heated arms of 40 W each, driven by the 95 W WT1M supply unit. The active RTW tips are at temperature after 5 seconds.

Benefits in use

• WTMT MS desoldering tweezers with 2 x 40 W release both terminals at once, so the part comes off without levering.
• Active RTW tip technology with a 5 second heat up time, short heat exposure protects solder resist and pads.
• Control from 50 to 450 °C at ±2 °C stability, the temperature stays inside the process window for the whole removal.
• WSR 211 safety rest with stop and go, the tweezers reduce their temperature while parked.
• The supply unit takes more than ten WT range tools, so the rework position can become a soldering position when needed.

Applications

Component replacement and rework on SMD assemblies, failure analysis, prototype build, repair and test areas. Suitable for package sizes from the smallest chips up to standard components.

Compatibility and scope of delivery

The set contains the WT1M supply unit for 230 V, the WTMT MS micro tweezers with 80 W at 24 V, the RTWMS 030 K micro tips with 2 x 40 W and the WSR 211 safety rest with stop and go. Further RTW tips and further WT range tools can be added. A connection to ZeroSmog fume extraction is provided for.

Standards and compliance

ESD safe according to the manufacturer and intended for EPA workstations to IEC 61340-5-1. Manufacturer details under GPSR, WELLER Tools GmbH, Carl-Benz-Strasse 2, DE-74354 Besigheim, www.weller-tools.com.