ESD repair station with DT530, T245, JT-T2A hot air 700 W and MSE module - JBC RMSD-2QB

The angled DT530 desoldering iron works flat over the board while the MSE module extracts at 85 % vacuum and the JTSE station puts out 700 W of profiled hot air. The DDE control unit also carries the T245 general purpose handle at up to 150 W. Soldering, desoldering and hot air then live on one bench.

Key benefits

• The tip type decides compatibility. The T245 takes cartridges of the C245 range, the DT530 works only with desoldering tips of the D530 range.
• The JTSE hot air station delivers 700 W, controls 150 to 450 °C and sets airflow between 5 and 50 SLPM.
• 25 hot air profiles with up to 10 steps each plus a type K thermocouple input keep the thermal curve on the part repeatable.
• The MSE module draws with 42 W, 85 % vacuum and 35 SLPM flow, controlled by pedal if wanted.
• Intelligent heat management lowers temperature during breaks and extends the life of cartridges and desoldering tips.
• USB-A takes firmware, graphics and profiles and connects a Dino-Lite USB microscope of models AM2011 and AM2111, USB-B goes to the PC and RJ12 drives extraction, peripherals or robots.

Applications

Repair and rework on populated boards, removal of connectors and through hole parts, work around BGA sites, service workshops and test areas.

Compatibility and scope of delivery

The delivery covers the DDE control unit for two tools, the T245 general purpose handle, the angled DT530 desoldering iron, the electric MSE desoldering module and the JTSE hot air station with the JTT heated hose set and the JT-T2A hot air tool. Hot air nozzles and DT530 wear parts are available separately.

Standards and compliance

The station complies with CE standards and is built ESD safe. Tip and ground meet ANSI/ESD S20.20 and IPC J-STD-001F, and the hot air module complies with ANSI/ESD S20.20-2021. Manufactured by JBC Soldering SL in Molins De Rei, Spain.