ESD rework station with DME 4 channel control unit, T245, DR560 and MSE module - JBC DMSE-2QD

Residual solder in a plated through hole is pulled out by the MSE module at 85 % vacuum and 35 SLPM flow, without a second pass. The DME control unit feeds up to four tools with 150 W peak power each. The station ships with the T245 general purpose handle and the DR560 desoldering iron.

Key benefits

• The cartridge type decides compatibility. The T245 handle takes cartridges of the C245 range, the DR560 works with desoldering tips of the C560 range.
• Four channels on the DME control unit, compatible with 13 different JBC tools. Two channels stay free for later additions.
• 150 W peak power per tool at 200 W rated power, so even a joint on a ground plane reaches temperature quickly.
• Working range 90 to 450 °C, stable to ±1.5 °C at idle. That meets and exceeds IPC J-STD-001F.
• The MSE module draws with 42 W, 85 % vacuum and 35 SLPM, controlled by the pedal connection if wanted.
• USB-A takes firmware, graphics and profiles and connects a Dino-Lite USB microscope of models AM2011 and AM2111, USB-B goes to the PC and RJ12 drives extraction, peripherals or robots.

Applications

Desoldering through hole components, removing residual solder after SMD rework, repair and test areas in electronics production and small batches with changing component sizes.

Compatibility and scope of delivery

The delivery covers the DME control unit for four tools, the T245 general purpose handle for the C245 cartridge range, the DR560 desoldering iron for the C560 tip range and the electric MSE desoldering module. Further JBC tools can be plugged into the free channels.

Standards and compliance

The station complies with CE standards and is built ESD safe. Voltage and resistance between tip and ground meet and exceed ANSI/ESD S20.20 and IPC J-STD-001F. Manufactured by JBC Soldering SL in Molins De Rei, Spain.