ESD Safety Low Shoe FLASH 5400 S2, SportLine upper, width 10, black/blue - Atlas 19800

Anyone walking several kilometres a day through a plant notices by the end of the shift whether the sole returns energy or swallows it. The FLASH 5400 ESD combines the MPU INNOFLEX outsole system of the FLASH series with an aluminium toe cap instead of steel and with the ESD equipment a protected area to DIN EN 61340-5-1 requires.

What this model delivers

• Standard width 10. Width 10 is the Atlas normal width and fits the majority of a workforce. For wider feet the same model is available in widths 12, 13 and 14 without changing the protection class.
• The charge goes into the floor, not into the assembly. The ESD equipment makes the shoe part of the EPA to DIN EN 61340-5-1. On a dissipative floor the wearer charge drains continuously instead of building up until someone reaches for a board.
• alu-tec cap, noticeably lighter than steel. The anatomically shaped aluminium toe cap shifts the centre of gravity towards the middle of the foot and helps prevent trips caused by imbalance. Aluminium is thermally neutral, so no cold bridge forms inside the shoe. EN ISO 20345 requires every toe cap to hold 200 joules impact energy and 15 kN compression.
• S2 in plain words. Closed heel area, antistatic construction, energy absorbing heel and a water repellent upper. Penetration resistance is not part of S2, which keeps the shoe light.
• MPU INNOFLEX outsole system. The INNOFLEX LINE guides forces from heel to toe, the CLOUDZONE in the heel absorbs impact, the DYNAMIC PLATES in the forefoot transfer forward energy. Slip resistance SR.
• SportLine upper. The textile fabric is air permeable and breathable, and its hydrophobic finish also makes it water repellent, quick drying and hard wearing. The aktiv-X functional lining regulates moisture inside the shoe.
• Cushioning and insoles. The 3D cushioning system combines a pressure relieving insole with a responsive MPU midsole. The abrasion resistant MPU toe guard extends service life during kneeling work, and the model is approved for orthopaedic insole fitting under DGUV rule 112-191.

Applications

Electronics manufacturing and PCB assembly, test and repair benches, mechanical assembly and final inspection, goods receipt, warehouse and order picking with long walking distances, and office staff who enter the shop floor.

Standards and conformity

• EN ISO 20345:2022, safety footwear for professional use, protection class S2 SR. The manufacturer lists the article under this edition.
• Aluminium toe cap, EN ISO 20345 requirement of 200 joules impact energy and 15 kN compression
• Slip resistance SR
• ESD equipment for workplaces to DIN EN 61340-5-1. EN ISO 20345 itself only verifies the antistatic range, the ESD proof belongs to the workplace concept.
• PPE Regulation (EU) 2016/425, risk category II
• Suitable for orthopaedic insole fitting under DGUV rule 112-191
• Manufacturer ATLAS-Schuhfabrik GmbH & Co. KG, Dortmund

Sizes and delivery

Available in EU sizes 36 to 49 in width 10. Supplied as one pair.