ESD safety low shoe SL 825 XP blue S1PS SR, width 12 extra wide, SportLine - Atlas 69912

A shoe that fits at the heel and pinches at the ball comes off as soon as nobody is looking, and the ESD protection goes with it. The SL 825 XP blue is therefore also made in extra wide width 12. Class, cap and penetration resistance stay the same: S1PS SR to EN ISO 20345:2022, an aluminium cap rated for 200 joules, a metal-free XP insert and a resistance below 100 MOhm to DIN EN 61340-5-1.

What the shoe does on the shop floor

• ESD shoe to DIN EN 61340-5-1. In the person-shoe-floor system the resistance stays below 100 MOhm, so the wearer's charge drains off in a controlled way instead of discharging into a component.
• Width 12, extra wide instead of standard width 10. The last is cut wider, length and protection class stay the same.
• Aluminium toe cap (alu-tec), tested to EN ISO 20345 for 200 joules of impact energy and 15 kN of compression. Aluminium weighs less than steel and forms no cold bridge across the forefoot.
• Metal-free XP penetration-resistant insert made from aramid fabric. It covers the full sole area, weighs less than a steel midsole and leaves the foot its natural torsion.
• SportLine upper, an air-permeable textile fabric that keeps the shoe light and moves perspiration outwards.
• MPU REBOUND SYSTEM in the sole. It absorbs impact energy at the heel and returns it into the roll-off, which is what counts across eight hours of standing and walking.

Areas of use

Electronics manufacturing and assembly lines, test benches, warehousing and picking in EPA zones, wherever wearers with high foot volume have to be equipped.

Standards and conformity

Class S1PS to EN ISO 20345:2022 means closed heel area, antistatic build, energy absorption in the heel and penetration resistance. The trailing S marks the metal-free penetration-resistant insert, tested with the 3.0 mm nail. SR stands for slip resistance on ceramic with glycerine. For the ESD workplace, DIN EN 61340-5-1 is the governing standard. It measures the person-shoe-floor system, and the value has to stay below 100 MOhm. At the lower end the shoe standard caps the resistance at 0.1 MOhm so that the shoe still insulates during work up to 230 V. The antistatic range of the shoe standard itself runs from 0.1 MOhm to 1,000 MOhm.

The shoe is personal protective equipment of category II under PPE Regulation (EU) 2016/425. The model is approved for orthopaedic insoles to DGUV rule 112-191, the marking inside the shoe is what counts. The EU declaration of conformity is provided by the manufacturer ATLAS-Schuhfabrik in Dortmund.

Sizes

The article covers sizes 36 to 49, and each size can be ordered as its own variant. The sales unit is one pair.