ESD Safety Low Shoe RUNNER 95 S3 SRC, microfibre upper, width 10, anthracite - Atlas 89700

Anyone walking several kilometres a day in production buys the shoe on weight and climate, not on the brochure. The RUNNER 95 combines protection class S3 SRC with a hydrophobic microfibre upper and the clima-stream concept while keeping body-shoe-floor resistance to DIN EN 61340-5-1 below 100 MOhm.

What this model delivers

• The charge goes into the floor, not into the component. Atlas states a body-shoe-floor resistance below 100 MOhm to DIN EN 61340-5-1 for its ESD footwear. The wearer is discharged continuously instead of building up a potential until the moment of contact with an assembly. EN ISO 20345 itself has no ESD test, it only defines the antistatic band from 100 kOhm to 1,000 MOhm.
• Class S3 in plain terms. Closed seat region, antistatic properties and an energy-absorbing heel, plus a water-repellent upper, penetration resistance and a cleated outsole. S3 is the class for production, workshop and warehouse where nothing has to be added later.
• XP penetration resistance, metal-free. Instead of a steel midplate Atlas uses a high-tech textile containing aramid fibres. Protection against nails and swarf covers the full sole area, stays light and does not fight the natural torsion of the foot. Metal-free also means no cold bridge and no alarm at a security checkpoint.
• MPU REBOUND SYSTEM. The responsive MPU midsole absorbs heel strike and returns energy during roll-off. Anyone standing eight hours on concrete or covering long distances across the plant notices the difference by the end of the day.
• clima-stream concept. The construction moves air through the shoe interior, balances moisture and keeps foot temperature stable. In a production hall with long wearing times that is the difference between wearable and irritating.
• aktiv-X functional lining. The lining regulates moisture actively and lets the shoe dry out again after the shift. It does not stain, is skin-friendly and abrasion-resistant, which is what counts over months of daily wear.
• Approved for orthopaedic insoles. The model is suitable for orthopaedic insole fitting to DGUV rule 112-191. The marking inside the shoe is decisive. Staff with their own insoles do not have to switch to a special model.

Technical data

Areas of use

Electronics manufacturing and assembly, test field and final inspection, assembly lines, service and maintenance, and warehouse and order picking with long walking distances across the shift.

Standards and conformity

• EN ISO 20345, safety footwear for professional use, class S3 SRC
• Toe cap to EN ISO 20345, tested at 200 joules impact energy and 15 kN compression
• Metal-free penetration resistance across the full sole area
• ESD equipment for workplaces to DIN EN 61340-5-1. Atlas states a body-shoe-floor resistance below 100 MOhm
• Antistatic band of EN ISO 20345 from 100 kOhm to 1,000 MOhm. The footwear standard itself requires no ESD test
• DGUV information 112-191 names 0.1 MOhm as the lower resistance limit for limited protection against dangerous body currents when working up to 230 V
• Suitable for orthopaedic insole fitting to DGUV rule 112-191
• PPE Regulation (EU) 2016/425, risk category II
• Manufacturer ATLAS-Schuhfabrik, Frische Luft 159, 44319 Dortmund, Germany

Sizes and scope of delivery

Available in EU sizes 36 to 48 in width 10 (standard width). One pair is supplied.