Endura ThermoDrive Desoldering Tip 1.02 mm for SX-70/SX-80 - PACE 1121-0624

When extracting through-hole joints, tip size decides the result. The inside diameter must fit over the lead and leave room for air and solder, while the outside diameter should be slightly smaller than the pad. At 1.02 mm I.D. and 2.29 mm O.D., this ThermoDrive tip matches many standard lands.

Benefits

• 1.02 mm I.D. fits standard leads with enough clearance for vacuum flow
• 2.29 mm O.D. stays on the pad and protects the laminate
• Endura version, intended by PACE for the SX-70 and SX-80
• Sold individually, also part of Endura Tip Kit 6993-0212

Specifications

Applications

• Removing through-hole DIP ICs, resistors and diodes
• Clearing holes for component replacement

Compatibility

• Sodr-X-Tractor SX-70 and SX-80
• For SX-90/SX-100 use version 1121-0931