Measuring Case Set Labeohm EVO with two shielded probes 63 mm - Iteco 9265056

An EPA audit needs more than the meter alone, it needs defined electrodes and a transport container. The Labeohm EVO case set holds the meter 9265.051 and two shielded probes 9265.065 of 63 mm diameter and 2.3 kg contact weight each, 5.5 kg of test equipment in total.

Operating benefits

• Two identical probes with defined contact weight make point to point measurement reproducible in the usual test set-up.
• The Labeohm EVO meter reads to half a decade and shows one significant digit on the graphic display.
• Acoustic alarm with programmable threshold reports limit violations during the walk.
• Everything in one case, meter, probes, cords and battery stay together and are ready for use.
• Without external probes the meter still reads surface resistance through its two embedded parallel electrodes.
• Measuring range 10^4 to 10^12 ohm with automatic test voltage of 10 V or 100 V.

Typical applications

• Periodic verification of the EPA with point to point measurement on floors, mats and worktops.
• Acceptance of newly laid ESD floor coverings with two probes of identical design.
• Mobile audit equipment for several sites, since the case carries every part.
• Evidence for the ESD control programme to IEC 61340-5-1.

Compatibility and scope of delivery

The set can be extended by the concentric ring probe 63/30 mm at 2.5 kg (Iteco 9265.070), the counter-electrode 150 x 150 mm (Iteco 9265.047) and the 25 cm T-handle with M5 thread (Iteco 9265.072). The same configuration with the simpler meter carries the number Iteco 9265.057. If test voltages up to 500 V and a measurement memory are also needed, move to the Gigalab EVO case set Iteco 9265.064.

Standards and origin

The electrode arrangement of the meter follows DIN EN 100015/1, the tests serve the monitoring of the EPA to IEC 61340-5-1. A traceable ISO 9000 calibration report is enclosed, recalibration can be ordered as Iteco 9265.003. Made in Italy.