2in1 Reworkstation digital 1350W, hot air (1280W) up to 500°C, soldering station (70W) up to 480°C with 6-piece accessory set - Quick QU709D+SET1

A QFP over a solid ground plane drains heat faster than a small hot air station can replace it. The 709D+ answers with 1280 W of heating power and an airflow of up to 50 l/min, adjustable in 100 steps.

Features

• 1350 W total, of which 1280 W drive the hot air channel from 100 to 500 °C
• Airflow in 100 steps up to 50 l/min, fine dosing for small parts and full volume for BGA and connectors
• Heat-up time of roughly 50 seconds to 350 °C, short waits between two repairs
• 70 W 901RAA iron from 100 to 480 °C within 2 °C for touch up on the same unit
• Three nozzles at 3 mm, 6.4 mm and 8.4 mm supplied, covering single chip resistors through to SOIC
• Auto standby on the air channel and digital calibration of both channels

Specifications

Where it is used

Removing and placing larger packages on multilayer boards, power electronics, shielding cans and connectors. A bench that only swaps small SMD parts and is short on space is served by the compact 707D+ with 800 W and 30 l/min.

Compatibility

Tips of the QUICK 960 series, 936-10 tip nut for the TS1100 and 709D+ iron, hot air nozzles of the A2000 range.