Kartuschenlötspitze für TS8, gerade, meißelförmig stumpf 1,6 mm breit x 0,5 mm, 5 mm Lot-benetzt - Quick TSS08-1.6D

An everyday bench tip needs contact area without bulk. The TSS08-1.6D offers a 1.6 mm blade width at only 0.5 mm thickness, covering a standard lead completely while still fitting into tight rows.

Key points

• Contact face 1.6 mm wide spreads heat across pad and lead instead of a single point.
• Edge only 0.5 mm thick, the thinnest blade of this width in the TSS08 range, for access between closely spaced pins.
• Tinning over 5 mm, the largest reservoir among the blades up to 2 mm wide, for dragging a complete pin row.
• Thermocouple inside the cartridge, so regulation follows the actual heat drain at the joint.
• Calibration chip in the tip, every tip carries its own correction value to the station.

Specifications

Use and scope of delivery

Intended as the standard tip on a repair or production bench, for drag soldering SOIC and QFP rows, pin headers, connector pins and medium through hole parts. The tip fits the QUELKTSS80A iron of the Quick TS8 and TS8+ stations. Supplied as one cartridge tip without iron or station.